New Features
Controller Firmware Update Feature
The GNSS Controller firmware can now be updated from within the SC Pilot Application (as well as Pilot Updater Application).
If automatic updates are enabled, the system will perform a check on app startup and apply the latest controller firmware.
If automatic updates are disabled, the manual update can be completed from “System Management” → “Controller Firmware Update”.
This function will only work if the system has a valid internet connection.
When controller firmware is updating, do not turn off the machine key or disconnect the communication device (modem) during this operation.
Improved Destination Navigation
Previously you could navigate to a destination from the mini-map on the main Machine Guidance screen. The mini-map has now been removed and you can set a destination (control point, survey point, or any coordinate) directly from the side panel.
To do this,
Turn on “Navigation Mode” in application settings
Access the navigation function from the side menu
Other Updates and Fixes
-
Updated GNSS Info to display only relevant information when connected to Gen2 controller
-
Enhanced performance of cross section and profile views
-
Fixed an incorrect swing boom default parameter (PC88)
-
Fixed an issue relating to GNSS heading during machine calibration
-
Fixed an issue where position check was providing invalid result if pressure sensor are not connected
-
Fixed an issue when sending multiple projects, were not correctly syncing via SC Pilot Web
-
Fixed an issue where some screens were unavailable (black screen) during remote support session