Skip to main content
Main navigation
Close navigation
Main
Main
General
iMC 1.0
iMC 2.0
iMC 3.0
iMC 3.0 Excavator
3D Boundary Control
Payload
Machine Setup
Joystick Pattern Selection
Lever Switch Assignment
How to Load a New Project File on the Machine
How to Add a New UHF Frequency
How to Connect the Machine to an NTRIP Correction Source (K-RTK, AllDayRTK, VRSNow, HxGN Smartnet)
How to Adjust Cutting Edge Wear
How to Position Check the iMC System
Daily Walk-Around Tech Checks (Antenna, Cables, Sensors)
How to Perform a Bucket Cylinder Reset
How to Enable Object Avoidance
Swing/ Travel to line initial setup
Travel Along Line
Swing to Line
Smart Construction
Troubleshooting articles
Breadcrumbs
Home
Intelligent Machine Control
iMC 3.0
iMC 3.0 Excavator
Machine Setup
On this Page
Lever Switch Assignment
